sparksacademychennai@gmail.com +91 8190879379 Saidapet, Chennai

MCQ - TNPSC JTO

JTO - 551 - Engineering Drawing and Draughtsman

551 - unit - 04 - Hatching Techniques in Sectional View

1)   

  The standard angle used for hatching lines is:

A.
B.
C.
D.
Answer: C
2)   

 Hatching is mainly used to show: 

A.
B.
C.
D.
Answer: C
3)   

 In assembly drawings, adjacent components are hatched:

A.
B.
C.
D.
Answer: C
4)   

  When hatching a large area, lines should be:

A.
B.
C.
D.
Answer: B
5)   

 Hatching in areas with different parallel planes should be drawn:

A.
B.
C.
D.
Answer: D
6)   

 Dimension lines within hatched areas should:

A.
B.
C.
D.
Answer: C
7)   

  Thin sections like sheet metal are usually:

A.
B.
C.
D.
Answer: A
8)   

 Hatching is omitted in:

A.
B.
C.
D.
Answer: C
9)   

  In thin wall components, hatching is: 

A.
B.
C.
D.
Answer: B
10)   

 The purpose of alternating hatch directions in assemblies is to: 

A.
B.
C.
D.
Answer: C
11)   

Which of the following is  not  a hatching rule? 

A.
B.
C.
D.
Answer: C
12)   

 Hatching angle for general-purpose section views is:

A.
B.
C.
D.
Answer: C
13)   

 When dimensioning inside hatched areas, hatching lines should be:

A.
B.
C.
D.
Answer: C
14)   

 The line spacing in hatching depends on: 

A.
B.
C.
D.
Answer: B
15)   

 In assembly sections, hatching is used to indicate: 

A.
B.
C.
D.
Answer: C
16)   

Which type of section shows the object cut completely in half?

A.
B.
C.
D.
Answer: C