MCQ - TNPSC JTO
JTO - 436 - Fitter
436 - Unit V Limit Fit Tolerance and Interchangeabilty
33)
In BIS notation H7, “H” indicates:
A.
B.
C.
D.
34)
In BIS notation g6, “6” represents
A.
B.
C.
D.
35)
In the BIS chart, upper deviation for a hole is denoted by:
A.
B.
C.
D.
36)
In the BIS chart, lower deviation for a shaft is denoted by:
A.
B.
C.
D.
37)
In the BIS chart, lower deviation for a shaft is denoted by:
A.
B.
C.
D.
38)
In the BIS chart, lower deviation for a shaft is denoted by:
A.
B.
C.
D.
39)
In BIS charts, capital letters (H, G, F) are used for:
A.
B.
C.
D.
40)
In BIS charts, small letters (h, g, f) are used for:
A.
B.
C.
D.
41)
In a hole basis system, the:
A.
B.
C.
D.
42)
The most widely used system in manufacturing is:
A.
B.
C.
D.
43)
The main reason the hole basis system is preferred is:
A.
B.
C.
D.
44)
In a shaft basis system, the:
A.
B.
C.
D.
45)
Shaft basis system is generally used when
A.
B.
C.
D.
46)
In BIS notation, H7/h6 represents
A.
B.
C.
D.
47)
In BIS notation, h7/H6 represents:
A.
B.
C.
D.
48)
Which of the following is an advantage of the hole basis system?
A.
B.
C.
D.