sparksacademychennai@gmail.com +91 8190879379 Saidapet, Chennai

MCQ - TNPSC JTO

JTO - 436 - Fitter

436 - Unit V Limit Fit Tolerance and Interchangeabilty

65)   

If a shaft is designated g6 in BIS, “g” represents:

A.
B.
C.
D.
66)   

In BIS charts, clearance is calculated by:

A.
B.
C.
D.
67)   

In BIS charts, maximum interference is calculated by:

A.
B.
C.
D.
68)   

Which of the following BIS fit designations is most likely to give an interference fit?

A.
B.
C.
D.
69)   

In the BIS system, H8/f7 is generally used for:

A.
B.
C.
D.
70)   

The BIS chart is designed mainly to:

A.
B.
C.
D.
71)   

The notation H7/g6 in IS system means:

A.
B.
C.
D.
72)   

In IS system, the letter H in a hole designation indicates:

A.
B.
C.
D.
73)   

In IS system, the letter h in a shaft designation indicates:

A.
B.
C.
D.
74)   

Loose running fits in IS system are generally used for:

A.
B.
C.
D.
75)   

Sliding fit in IS system is best suited for:

A.
B.
C.
D.
76)   

Force fit in IS system is a type of

A.
B.
C.
D.
77)   

The designation IT7 in IS system refers to:

A.
B.
C.
D.
78)   

The push fit in IS system is classified under:

A.
B.
C.
D.
79)   

A drive fit in IS system is generally used for:

A.
B.
C.
D.
80)   

In IS fit classification, a medium force fit is used where:

A.
B.
C.
D.