MCQ - TNPSC JTO
JTO - 538 - Industrial Robotics and Digital Manufacturing
538 - Unit III Knowledge of Industrial Engineering Drawing
129)
The clearance is the difference between:
A.
B.
C.
D.
130)
Zero clearance occurs in:
A.
B.
C.
D.
131)
If a shaft is always smaller than the hole, the fit is:
A.
B.
C.
D.
132)
Which tolerance system is universally used?
A.
B.
C.
D.
133)
Fundamental deviation is:
A.
B.
C.
D.
134)
Shaft basis system is mainly adopted when:
A.
B.
C.
D.
135)
The difference between maximum material limit of hole and shaft is:
A.
B.
C.
D.
136)
The system of limits and fits used in India is recommended by:
A.
B.
C.
D.
137)
A tolerance grade IT7 is:
A.
B.
C.
D.
138)
Clearance fit is usually preferred in:
A.
B.
C.
D.
139)
Interference fit is generally used in:
A.
B.
C.
D.
140)
The main purpose of providing tolerance is:
A.
B.
C.
D.
141)
The main purpose of an industrial drawing is to:
A.
B.
C.
D.
142)
In an engineering drawing, the "title block" is used to show:
A.
B.
C.
D.
143)
Which type of projection is widely used in industrial drawings in India?
A.
B.
C.
D.
144)
Sectional views in a drawing are provided to:
A.
B.
C.
D.